Providing you the best range of Alloy Steel - Full Hardening Steel such as Alloy Full Hardening Steel -Gr. EN-19, EN-31 Full Hardening Steel and EN-24 Full Hardening Steel with effective & timely delivery.
Item Code: EN-19
EN19 is a high quality, high tensile alloy steel usually supplied readily machineable in ‘T’ condition, giving good ductility and shock resisting properties combined with resistance to wear. EN-19 is Suitable for highly stressed applications where greater strength is required. Hardening: Heat uniformly to 820/840°C until heated through. Quench in oil. Tempering: Heat uniformly and thoroughly at the selected tempering temperature, and hold at heat for one hour per inch of total thickness. We also have forged bars Diameter upto 400mm Applications: Axles , Rifle Barrels, Drive Shafts, Breech Mechanisms for Small Arms, Crankshafts, Induction Hardened Pins, Connecting Rods, High Tensile Bolts, Studs, Propeller Shaft Joints.
Available with us a distinguished range of EN Series Bars/Flats, which is manufactured by our vendors using premium quality steel. Our cordial relation with the vendors enables us in delivering bulk requirements of the clients within the time limit. These products are widely used in automobile industries for various purposes. Some of the salient features of the products are as follows: Dimensional accuracy Enhanced durability Tensile strength Corrosion resistance High carbon alloy steel which achieves a high degree of hardness with compressive strength and abrasion resistance Applications : For roller bearing components such as brakes, cylindrical , conical & needle rollers.
EN24 is a high quality, high tensile, alloy steel . Usually supplied readily machineable in ‘T’ condition, it combines high tensile strength, shock resistance, good ductility and resistance to wear. Hardening: Heat uniformly to 823/850°C until heated through. Quench in oil. Tempering: Heat uniformly and thoroughly at the selected tempering temperature, up to 660°C and hold at heat for two hours per inch of total thickness. Tempering between 250-375°C in not recommended as this can seriously reduce the steels impact value. Stress Relieving: Heat slowly to 650-670°C, soak well before cooling the EN24 tool in a furnace or in air. Sizes Available are in rounds, Squares and flats Applications : Highly stressed components of large cross section for aircraft, automotive & general enginery application such as propeller shafts, connecting rods, gear shafts, crane shafts & landing gear components, heavy forging, such as rotar shafts & discs.